Input Voltage Range of LED Power Supplies

Jul 11, 2025

Leave a message

If the UPS's battery transfer device is a relay, damage to the relay is particularly severe, significantly increasing the UPS's failure rate.

Voltage Protection Level (Up): The peak value of the standard lightning pulse breakdown voltage, the residual voltage at the protected terminal at the rated discharge current Isn. For power system lightning arresters, the protection level determines their installation location based on the overvoltage classification (1, 2, 3, 4); for information system arresters, the protection level must match the compatibility of the system and equipment to be protected.

Operating Voltage: The operating voltage refers to the voltage required for normal CPU operation. With improvements in CPU manufacturing processes and main frequencies, the CPU's operating voltage has gradually decreased. Low voltage can address issues such as excessive power consumption and excessive heat generation, which is particularly important for laptops.

Input Impedance: Impedance is the resistance of a circuit or device to AC current. Input impedance is the impedance measured at the input; it represents the amount of load placed on an input by the signal source driving it.

High input impedance minimizes signal changes during circuit connection and is therefore ideal. The minimum input impedance is the lowest impedance at a given voltage. As an alternative to or in addition to input current, it determines the input power requirement.

Voltage level (Uc)
The maximum voltage that can be applied to a specified terminal without causing a change in characteristics or triggering protective components.

Power factor
This value is usually between 0 and 1 and must never be greater than 1. It is the ratio between W (real power) and VA (imaginary power). The higher the ratio, the better the appliance's efficiency. Conversely, the lower the ratio, the greater the energy consumption and therefore the higher the power consumption.

Transient response capability
When the input voltage undergoes a large transient change (within the allowable range), the time it takes for the output voltage to return to normal is an indicator of the power supply's ability to respond to abnormal conditions.

Send Inquiry